Home

The various trusses for hip roof systems

Diagram of a truncated standard truss.

Truncated standard truss

This takes a standard truss shape but cuts off the top to suit the slope at the top of a hip end.


Diagram of a truncated girder truss.

Truncated girder truss

This is the main truss in a hip end. It occurs below the standard truncated trusses. It takes the load of the outer hip trusses including the hip, jack and creeper trusses. It is made stronger than the standard truncated trusses to take these loads.

Diagram of a hip truss.

Hip truss

This forms the hip line of the roof. It is similar to a half truss but has an extended top chord. This extends over the truncated girder truss and finishes as the top of the hip. Some jack and all creeper trusses butt into the hip truss.


Diagram of a jack truss.

Jack truss

This runs into the hip truss. It is similar to a half truss but with an extended top chord. This extends over the truncated girder and meets the hip truss.


Diagram of a creeper truss.

Creeper truss

This runs into the hip truss with no extension of the top chord. That is, it stops short of the truncated girder.



Diagram of a scissor truss.

Scissor truss

There is a modified standard truss to suit a sloping ceiling. Most scissor trusses have an equal pitch ceiling each side of the apex. Other ceiling lines are also possible.


Diagram of a bell truss.

Bell truss

This is a common roof shape for Federation and homestead style houses. The top chord has two pitches. The lower pitch is usually over a verandah or patio area.



Diagram of a bowstring truss.

Bowstring truss

This truss is mostly used as a commercial truss, however, it is becoming more common in the domestic sector. The top chords are designed to allow a curved roof.



Diagram of a cantilever truss.

Cantilever truss

This can actually be any type of truss but the support point on one or both sides is located inside the span, not at the heel. An extra web is required at the inner support location(s).



Diagram of a cut off truss.

Cut off truss

This can be any type of truss but does not have a heel. This truss shape is determined by the location and comparative height of the pitching lines on either side of the roof area.



Diagram of a half truss.

Half truss

A half truss is a full truss, cut off at the apex.